4/28/2023 0 Comments Dead cells builds![]() If the cells next to each other are good, then you don’t need to separate them, just leave them bundled together. Use a multimeter to determine if the cell is bad or not. When taking the cells apart, working in a warmer room help separating them more easily because the adhesive is less sticky when warmed up. Separate the good cells from the bad with a plastic tool, do not use metal to avoid puncturing the cells. Step 2 – Separating the bad cells from the good Remove the tape wrapping around the cell terminals, then unsolder the balance wire and XT60. ![]() This thicker flexible layer will help ensure that you do not puncture any of the cells with your knife. ![]() Make sure you are cutting on the side with the internal protective layer. Remove the exterior plastic packaging from the LiPo battery. My recommendation for all sorts of tools for building quads. A big bucket of sand to put out fires (just in case!).A multimeter to check battery cell voltages.I don’t think it’s a good idea to mess with LiPo, but if you must, do this outdoor to avoid burning the house down, or filling your house with toxic gasses from LiPo fire. It’s possible to make a good working LiPo using good cells from LiPo batteries of the same brand/specs in order to maintain the save cell count. Note that by removing a cell from LiPo battery, the nominal voltage also decreases – e.g. If you have a battery with dead cell, it’s best to just dispose of it, guide: how to dispose LiPo batteries. The author and are not responsible for any fires or damage caused. Over-discharged LiPo, first cell reads zero volt and can’t be re-chargedĭisclaimer: I DO NOT recommend doing this, it’s very dangerous working on defective LiPo.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |